Subject	anyone with 2m soldering experience could do it in 2 mins.
Posted by	fourZero on June 05, 2003 at 4:57 PM
	This message has been viewed 47 times.
In Reply To	Where would be a good place to have this work done? posted by Zride4me on June 05, 2003 at 04:55 PM
Message	A good TV repair shop should have a 2m certified solder tech that could do it literally while you wait. As far as the boost controller, you don't need it before the ECU is put in, but you're gonna SURELY want it afterwards. If you have the time and money, go ahead and put it in now, just don't boost past 10-11 psi or you'll be pulling your engine. "So I nailed it, took off like an F18 from carrier. Of course the chase begained." -Tim_N/A 04/07/03 "You're right, oil filtration is not important. From now on, I'm using a balled up sock in a soup can." -Spee 05/09/03
Follow Ups	question about socketing a JWT chip into ECU--> - Zride4me 16:41:31 06/05/03 get the proper socket, it will drop in - fourZero 16:43:42 06/05/03 Where would be a good place to have this work done? - Zride4me 16:55:04 06/05/03 anyone with 2m soldering experience could do it in 2 mins. - fourZero 16:57:21 06/05/03 Hey FourZero-->thanks a lot bro!! very helpful (n/m) - Zride4me 17:09:12 06/05/03 my pleasure (n/m) - fourZero 17:11:24 06/05/03 from Devin Novak's ECU page.. - fourZero 16:52:24 06/05/03 Radio Shack does sell the sockets. (n/m) - Woody75 (Denver) 17:09:14 06/05/03
Post a Followup	You cannot reply to this message because you are not logged in.