Subject	there was a braket on the side without a bolt in it
Posted by	genic on May 31, 2003 at 11:36 PM
	This message has been viewed 20 times.
In Reply To	What did you mount it to, though? The bumper? posted by Bernowt (So. Fla) on May 31, 2003 at 11:20 PM
Message	i found a bolt that fit and mounted it there...ran all the lines under the intake tubing.
Follow Ups	Guys w/ Blitz Dual Solenoid BCs (SBC-iD, DSBC, etc) - Bernowt (So. Fla) 23:10:06 05/31/03 i did mine up front under the center panel..and - genic 23:16:47 05/31/03 where is yours now? - Spee 23:18:46 05/31/03 vtb (n/m) - genic 23:39:34 05/31/03 I would have boughted it from you... - Spee 23:48:33 05/31/03 What did you mount it to, though? The bumper? - Bernowt (So. Fla) 23:20:28 05/31/03 there was a braket on the side without a bolt in it - genic 23:36:09 05/31/03 Hmm, thanks. I'll have to take a closer look under there. (n/m) - Bernowt (So. Fla) 23:38:55 05/31/03 should be one on the right hand side as your facing the pop - genic 23:40:10 05/31/03 Speddmon13 mounted my Profeb-B solenoid here.. - Wui (Philly) 23:54:34 05/31/03 thats were i did mine and another persons. - genic 23:56:36 05/31/03 Thanks a lot guys. Very helpful :-) (n/m) - Bernowt (So. Fla) 00:02:11 06/01/03 bitch...mine wouldnt reach there! (n/m) - Chris(NJ) 00:11:26 06/01/03 Um... Get longer vac. line & wire. (n/m) - YugoBernie (NoVA) 01:43:42 06/01/03 oh sure, take the easy way out :P (n/m) - Chris(NJ) 09:16:44 06/01/03 between headlight and HICAS actuators - lymon 02:43:09 06/01/03 Sweet, thank you! (n/m) - Bernowt (So. Fla) 10:03:24 06/01/03 Nice location.... (n/m) - CowBoy--TT Conversion Underway 13:53:30 06/01/03 ... would be better to be away from engine heat. (n/m) - YugoBernie (NoVA) 20:50:27 06/01/03
Post a Followup	You cannot reply to this message because you are not logged in.