TwinTurbo.NET: Nissan 300ZX forum - take it from someone who did the clearing
People Seeking Info
 
   


     
Subject take it from someone who did the clearing
     
Posted by the_real_dummy on May 28, 2003 at 11:03 AM
  This message has been viewed 66 times.
     
In Reply To Clearing tail lights. posted by ~2turboz on May 28, 2003 at 10:46 AM
     
Message it's not worth it. it looks cheap and junky, i ended up getting the real j-specs. it wasn't that it was tough, or the job i did was bad, but the j-specs are 'clearly' better.

i have a link to a site that has the procedure at home i think. if you're sure you want it i can send it to you tonight. but basically, it goes like this :

heat oven to 400 degrees
wedge tail assembly in door, with the back end inside the oven door, the outside lenses holding the door open

leave for 10-12 minutes, NOT TOO LONG OR YOU MELT THE ASSEMBLY!

pull out, pry apart the bottom with a small screw driver and hands

pull yellow lense

put in white lense

close quickly! clamp to keep closed tight

my rides :
1990 300zx TT
2002 Ford Explorer Sport

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.