Subject	I was also looking for some ideas for this. I went to -->
Posted by	Zride4me on May 25, 2003 at 1:43 AM
	This message has been viewed 37 times.
In Reply To	After rear strut bar install, NE1 found a cover up >> posted by ZX NAT on May 25, 2003 at 12:55 AM
Message	Pepboys and bought the door edge guards(thin u-shaped rubber in black). My idea is to use that around the edges where I cut to mount the strut bar. I think it should look ok when done...I hope!
Follow Ups	After rear strut bar install, NE1 found a cover up >> - ZX NAT 00:55:56 05/25/03 I was also looking for some ideas for this. I went to --> - Zride4me 01:43:26 05/25/03 It looks good..Finishes it out nicely.I used black silicone - AndrewZ 10:59:28 05/25/03 I'm still finding the courage to cut the hole... (n/m) - Zonic_BoomZ 05:07:48 05/25/03 im working on a shift boot kinda thing - dogpile 10:50:36 05/25/03 Use black silicone vacuum hose - NR98 (Ohio) 13:34:07 05/25/03 This has always worked for me: - YugoBernie (NoVA) 21:40:18 05/25/03
Post a Followup	You cannot reply to this message because you are not logged in.