Subject	Need to install black strip on hatch...
Posted by	Z CRAZY on May 23, 2003 at 11:24 AM
	This message has been viewed 244 times.
Message	This is the plastic strip that goes just below the rear spoiler on my 90TT. It is the black piece that the Nissan and Twin Turbo sticker stick on to. I need to remove the molding on the hatch to install it because the bottom edge of the strip rolls under this molding. How does this molding come off? On the sides of the hatch are phillips screws, about four on each side. Just below the spoiler is the molding I'm referring to. I don't think I have to remove the spoiler, just the molding underneath. Also, are there any tricks to make sure I don't end up with air bubbles under the black strip when I install it? Thanks
Follow Ups	Need to install black strip on hatch... - Z CRAZY 11:24:43 05/23/03 Moulding slides out when you take out the screws. (n/m) - YugoBernie (NoVA) 11:29:17 05/23/03 If I remember right the molding just pulls off. (n/m) - Woody75 (Denver) 11:45:02 05/23/03 Re: Need to install black strip on hatch... - TT-Z 12:18:59 05/23/03 I needed this info as well. installing my strip today or - hoss 14:36:24 05/23/03
Post a Followup	You cannot reply to this message because you are not logged in.