| Message |
I'm good friend's with the import shop near my house and was talking with the owner about getting a stillen ducted panel. He mentioned an idea of taking my stock panel and cuting out the pattern I wanted (possibly remove hamburger logo and fill in holes), then repaint and tact weld mesh on the back. I brought up the water on pop charger issue and he said that we could just take a curved metal sheet and attach that on the inside so any water would run and drip off to the sides.
So opinions on this, please?
I'm thinking of doing the narrow three slotted look on each side much like the stillen or just go for two slots on each side. I could also have a patten where the outside corners are much like this [( eith that half moon cut on the inside and match it with (| on the side of the moon cut {course this is if u get this}
Can anyone photoshop any of this on a red Z with mesh on the inside.I think this might be different and a unique way to go about this other than buying a ducted panel. I know the guys at the shop well and they will do a good job cheap. Than, I will just need to get it painted. Thanks
Josh
|
 |
