Subject	Negative, ghostrider.
Posted by	fourZero on May 23, 2003 at 12:06 AM
	This message has been viewed 41 times.
In Reply To	you do know each end is a different width?? posted by TARGETZ on May 23, 2003 at 12:02 AM
Message	I followed the instructions to a T, put the 112mm tube in the side closest to the engine. I used to be an avionics tech. We're anal about following directions. Even after 4mm of material off, it was still hard to get these things in (especially on the wheel side of the linkage. Lots of lovin' from the hammer. "So I nailed it, took off like an F18 from carrier. Of course the chase begained." -Tim_N/A 04/07/03 "You're right, oil filtration is not important. From now on, I'm using a balled up sock in a soup can." -Spee 05/09/03
Follow Ups	just finished installing Noltec A-arms - fourZero 23:49:12 05/22/03 you do know each end is a different width?? - TARGETZ 00:02:50 05/23/03 Negative, ghostrider. - fourZero 00:06:01 05/23/03 Mine were a PITA as well. took well over a hour of prying - wattz 00:15:39 05/23/03 there's no question that TBO > Noltec - fourZero 00:41:47 05/23/03 True... - powerZlide 02:18:00 05/23/03 labor is free - fourZero 11:40:05 05/23/03 yep, same problem - socos 11:05:39 05/23/03 One set we received had the sticker on the wrong side. - Chip(GinnMotorsports) 12:29:48 05/23/03 man, that's the LAST thing I wanted to hear - fourZero 13:33:38 05/23/03 DOH that sucks - TARGETZ 14:42:34 05/23/03
Post a Followup	You cannot reply to this message because you are not logged in.