Subject	Oh what a night (or however that song goes)
Posted by	SactoTodd on May 20, 2003 at 2:54 AM
	This message has been viewed 96 times.
Message	FINALLY, after a few weeks of evening wrench session, it's done. (almost) ST sway bars Nismo Tension Rods GinnMotorsports Big rotor kit Ricey painted calipers For some reason, things labeled as hard were easy, and the simple things were a pain. Rear bar came right out, when right back in. Tie links lined right up, not a problem. I had a stripped bolt for the rear sway bar mount, now I have two. :( Front bar came right out, after I removed the angley piece that the tension rod mounts to. New bar went right in. I did manage to cross thread the tiny bolt that holds the AC line up near the radiator. Put the angley pieces back in, bolted up the sway bar, attached the end links. Bolted in the T-Rods. In the T-rod install, it says to attach them before installing the angley pieces, huh, I had no problem. ROAD TEST. :) Now I might have to bite the bullet, and have a mechanic fix my sway bar mount *issue*. -Todd
Follow Ups	Oh what a night (or however that song goes) - SactoTodd 02:54:11 05/20/03 I take it you had no problems getting the Trod bolts pressed (n/m) - Snoguitar 02:57:34 05/20/03 none, really. - SactoTodd 03:05:59 05/20/03 Had same prob with sway mount-had to use heli-coil.PITA! (n/m) - zcar4me 04:44:06 05/20/03 What no pics? :-) (n/m) - spicyZ 07:11:52 05/20/03 Thanks for the update! - Dlee300z 11:25:09 05/20/03
Post a Followup	You cannot reply to this message because you are not logged in.