Subject	Put my WW kit on, and while doing it.........
Posted by	Jeremys92-2+2 on May 16, 2003 at 10:30 AM
	This message has been viewed 89 times.
Message	the rear bumper when putting it on it slid down some, so now you can see a little gap between the rear kit and the stock bumper. it looks fine but not how i want it. Is there anyway I could feel it in. Also anything i can do now since it is dry? Any help would be great. Thanks, Jeremy
Follow Ups	Put my WW kit on, and while doing it......... - Jeremys92-2+2 10:30:22 05/16/03 find a good fiberglass guy - Smurf Z 10:33:27 05/16/03 Have same kit and filling mine in, looks good in my opinion. (n/m) - Milo (San Antonio, TX.) 10:36:41 05/16/03 thank, but is there anyway to remove and start over.. - Jeremys92-2+2 10:39:50 05/16/03 I pushed the WW rear bumper higher, drilled in the center - Milo (San Antonio, TX.) 10:44:04 05/16/03 i did that.. - Jeremys92-2+2 10:47:18 05/16/03 It should fit kinda flush, I fitted mine about 15 times to - Milo (San Antonio, TX.) 11:06:36 05/16/03 Re: Put my WW kit on, and while doing it......... - Nadir(Detroit) 10:48:45 05/16/03 WOW look great how did u do that? (n/m) - Jeremys92-2+2 10:50:46 05/16/03 Looks like all one piece. Did you do the same - Jeremys92-2+2 10:52:34 05/16/03 yes my side skirts are also molded (n/m) - Nadir(Detroit) 11:01:12 05/16/03 clean lookin' Z... I'm usually not a fan of kits, but urs - Scotts94z32 11:12:19 05/16/03 nadir, could you email me with some info on how to do this? - SupermanZ(MD) 11:16:12 05/16/03 Ass end looks too big now though. - Woody75 (Denver) 11:39:08 05/16/03 2nd, looks like the Z is wearing a diaper (n/m) - ScubaSteve 13:29:31 05/16/03 Re: In Michigan we like a little meat on our women. - Z=MCSQD 13:54:19 05/16/03 here is what the WW rear in mid-molding process looks like> - Wagz 15:07:04 05/16/03 hey wagz, can you tell me what steps your bodyguy took to do - SupermanZ(MD) 16:44:28 05/16/03 urethane is supposedly hard/not good to do-mine is fiberglas - Wagz 18:55:09 05/16/03
Post a Followup	You cannot reply to this message because you are not logged in.