Subject	No, they are the angle made with the horizontal (+ more ??s)
Posted by	Scotts94z32 on May 16, 2003 at 9:50 AM
	This message has been viewed 33 times.
In Reply To	Quick question... posted by 1991TT on May 16, 2003 at 09:33 AM
Message	but what are the angles 2" OD pipes? What is the thickness of the pipe (i.e. the ID vs the 2 or 2.5" OD). Pipes should always be drawn from center lines, it makes the measurements easier and the drawings easier to understand.. SS ____________________________________________________________________________________________________ “Any intelligent fool can make things bigger, more complex, and more violent. It takes a touch of genius--and a lot of courage--to move in the opposite direction.”
Follow Ups	Could sombody E-mail a template for the Auto-Jet hardpipes (n/m) - TRD300Z 06:19:59 05/16/03 Search (n/m) - MatD 07:39:44 05/16/03 Here: - YugoBernie (NoVA) 08:43:16 05/16/03 Thanks (n/m) - TRD300Z 08:46:19 05/16/03 Been looking for that one myself... thanks (n/m) - spicyZ 09:25:14 05/16/03 Quick question... - 1991TT 09:33:21 05/16/03 No, they are the angle made with the horizontal (+ more ??s) - Scotts94z32 09:50:26 05/16/03 the drivers side pipe needs to be bent more. doesn't fit - Pure-Evil 14:37:47 05/16/03 AshSPEC Hardpipes. =) (n/m) - AshsZ (FabZEM All) 11:26:33 05/16/03 you're sitting on a gold mine - fourZero 11:31:59 05/16/03 Agreed, if that were to be done I'd buy a set (n/m) - acidW4rp (MA) 11:42:18 05/16/03 Agreed x2 (n/m) - Chaaarmndr (NoVA) 11:51:08 05/16/03 Agreed x3 (n/m) - Wui (Philly) 14:51:54 05/16/03 Agreed x4 (n/m) - Kez43 16:48:45 05/16/03
Post a Followup	You cannot reply to this message because you are not logged in.