Subject	Stillen vented nose
Posted by	orinoco (NC) on May 15, 2003 at 2:54 PM
	This message has been viewed 129 times.
Message	Hi, i just got a new stillen vented duct nose peice (ducted v2 type). I had to cut al lthe holes and stuff myself to fit the rubber seal and the lil metal strip to it. Anyhoo when it came to actually putting it on my car, i noticed there was a pretty good gap between the hood and the nose panel, has anyoen else experienced this and is there a remedy?
Follow Ups	Stillen vented nose - orinoco (NC) 14:54:05 05/15/03 i think thats 100% normal. (n/m) - ni[X]it 14:55:25 05/15/03 Yup. (n/m) - YugoBernie (NoVA) 14:58:49 05/15/03 Mine is the same way... (n/m) - LRD VDR 15:00:53 05/15/03 if thats the case i wont buy from Stillen again :( (n/m) - orinoco (NC) 14:58:55 05/15/03 Wonder if this was mentioned in Search before? :-/ (n/m) - YugoBernie (NoVA) 15:02:58 05/15/03 Stay away from STILLEN anyway. All their crap is overpriced (n/m) - BigRob 17:24:56 05/15/03 Mine took a little work to make fit right, but it came - Musashi Sword 15:50:52 05/15/03 Re: I had to use some shem's..Not right but worked out (n/m) - Z-Freak 16:16:49 05/15/03 Did you give up on the kit your making? (n/m) - Deja_Vu 16:25:14 05/15/03
Post a Followup	You cannot reply to this message because you are not logged in.