Subject	any Tech write ups on it? (n/m)
Posted by	Zero-Tolerence on May 12, 2003 at 11:59 AM
	This message has been viewed 20 times.
In Reply To	How much is labor for replacing a throwout bearing? (n/m) posted by ZMAN77 on May 12, 2003 at 08:29 AM
Message
Follow Ups	How much is labor for replacing a throwout bearing? (n/m) - ZMAN77 08:29:22 05/12/03 same as for a clutch...about $250-300 (n/m) - aliaZ 08:32:00 05/12/03 To save money, I'd make it a DIY job. (n/m) - Jdiknt2 09:10:45 05/12/03 Mines going out too :( You can do it yourself, just a PITA (n/m) - MugenRacer 09:12:30 05/12/03 make sure and have your RMS replaced as well (n/m) - BOOZTD 3 09:24:59 05/12/03 any Tech write ups on it? (n/m) - Zero-Tolerence 11:59:33 05/12/03 Its called drop your transmission... - KaZ (VaBch) 12:17:58 05/12/03 its the one for clutch replacement. (n/m) - Spee 13:12:58 05/12/03 There is a faq for that? Kew, I hadn't looked... - KaZ (VaBch) 13:49:23 05/12/03 case of beer and a couple buddies...DIY (n/m) - Spee 12:09:17 05/12/03 Don't forget Pizza, Cheezy Bread, and Cinnastix... (n/m) - KaZ (VaBch) 12:16:28 05/12/03 When I did it for the first time it took us like - MugenRacer 13:09:58 05/12/03 You should gut them off the car... - KaZ (VaBch) 13:48:51 05/12/03 I did. In a bench vise. (n/m) - MugenRacer 14:57:18 05/12/03
Post a Followup	You cannot reply to this message because you are not logged in.