Subject	Since its been in the works for alomst 2 years I was
Posted by	JMT-Z(St. Louis) on April 30, 2003 at 4:05 PM
	This message has been viewed 58 times.
In Reply To	This has been in the works for almost 2 years, ask Carlos R. posted by Chip(GinnMotorsports) on April 30, 2003 at 03:53 PM
Message	wondering if you have any flow data, like the data we had on the chart awhile back comparing open heads to stock, ported, extrudehoned, GD, greddy and pentroof manifolds? I know you are probably going to say you'll have it when you move into your next shop but I though I'd throw it out there. "If everything seems under control, you're just not going fast enough." - Mario Andretti
Follow Ups	Any besides Pentroof for tubular ex. manifold for TT that - MikeH(Twin GT35BB Incon Z) 14:18:20 04/30/03 gregs manifolds should be done sometime soon right ? - Chris(NJ) 14:24:13 04/30/03 I spoke with Greg, he is working on Inconel version but - MikeH(Twin GT35BB Incon Z) 14:26:13 04/30/03 Inconel isn't cheap... or easy to weld... - MugenRacer 14:48:07 04/30/03 afterall, it's what the Mclaren F1 uses for exhaust manis :) (n/m) - degradated 20:30:18 04/30/03 Last I heard it would be about 6 months.. - degradated 20:32:40 04/30/03 Hold tight, We will be releasing a few new products after - Chip(GinnMotorsports) 14:53:46 04/30/03 Sign me up :) (n/m) - LRD VDR 14:56:23 04/30/03 Also, there will be 2 versions >> - Chip(GinnMotorsports) 15:04:28 04/30/03 Umm Wow. No notching the frame for Big turbos? (n/m) - MugenRacer 15:20:52 04/30/03 Notching the frame is 100% dependent on compressor housing - Chip(GinnMotorsports) 15:30:13 04/30/03 Chip, I had no idea you were working on one. If not SS then - MikeH(Twin GT35BB Incon Z) 15:45:02 04/30/03 This has been in the works for almost 2 years, ask Carlos R. - Chip(GinnMotorsports) 15:53:20 04/30/03 Since its been in the works for alomst 2 years I was - JMT-Z(St. Louis) 16:05:03 04/30/03 The manifold that was in the works has been flow tested - Chip(GinnMotorsports) 17:17:06 04/30/03 I didn't know you can weld on cast steel . Cast is cast in - MikeH(Twin GT35BB Incon Z) 16:09:38 04/30/03 Examples: - Chip(GinnMotorsports) 17:28:28 04/30/03 You're talking about - RSR 07:04:20 05/01/03 What gauge steel? Hopefully at least 14 gauge. - teahead 09:55:02 05/01/03
Post a Followup	You cannot reply to this message because you are not logged in.