Subject	Chip, I had no idea you were working on one. If not SS then
Posted by	MikeH(Twin GT35BB Incon Z) on April 30, 2003 at 3:45 PM
	This message has been viewed 57 times.
In Reply To	Hold tight, We will be releasing a few new products after posted by Chip(GinnMotorsports) on April 30, 2003 at 02:53 PM
Message	what.. mild steel? My down pipes are made of mild steel and ceramic coated. But the they see less heat than the exhaust manifold. When do you expect to move?
Follow Ups	Any besides Pentroof for tubular ex. manifold for TT that - MikeH(Twin GT35BB Incon Z) 14:18:20 04/30/03 gregs manifolds should be done sometime soon right ? - Chris(NJ) 14:24:13 04/30/03 I spoke with Greg, he is working on Inconel version but - MikeH(Twin GT35BB Incon Z) 14:26:13 04/30/03 Inconel isn't cheap... or easy to weld... - MugenRacer 14:48:07 04/30/03 afterall, it's what the Mclaren F1 uses for exhaust manis :) (n/m) - degradated 20:30:18 04/30/03 Last I heard it would be about 6 months.. - degradated 20:32:40 04/30/03 Hold tight, We will be releasing a few new products after - Chip(GinnMotorsports) 14:53:46 04/30/03 Sign me up :) (n/m) - LRD VDR 14:56:23 04/30/03 Also, there will be 2 versions >> - Chip(GinnMotorsports) 15:04:28 04/30/03 Umm Wow. No notching the frame for Big turbos? (n/m) - MugenRacer 15:20:52 04/30/03 Notching the frame is 100% dependent on compressor housing - Chip(GinnMotorsports) 15:30:13 04/30/03 Chip, I had no idea you were working on one. If not SS then - MikeH(Twin GT35BB Incon Z) 15:45:02 04/30/03 This has been in the works for almost 2 years, ask Carlos R. - Chip(GinnMotorsports) 15:53:20 04/30/03 Since its been in the works for alomst 2 years I was - JMT-Z(St. Louis) 16:05:03 04/30/03 The manifold that was in the works has been flow tested - Chip(GinnMotorsports) 17:17:06 04/30/03 I didn't know you can weld on cast steel . Cast is cast in - MikeH(Twin GT35BB Incon Z) 16:09:38 04/30/03 Examples: - Chip(GinnMotorsports) 17:28:28 04/30/03 You're talking about - RSR 07:04:20 05/01/03 What gauge steel? Hopefully at least 14 gauge. - teahead 09:55:02 05/01/03
Post a Followup	You cannot reply to this message because you are not logged in.