Subject	Notching the frame is 100% dependent on compressor housing
Posted by	Chip(GinnMotorsports) on April 30, 2003 at 3:30 PM
	This message has been viewed 93 times.
In Reply To	Umm Wow. No notching the frame for Big turbos? (n/m) posted by MugenRacer on April 30, 2003 at 03:20 PM
Message	A big compressor housing does not make a turbo "big" in my view. I can take a Garrett GT3037 CHRA put a To4E compressor hosuing on it and flow much more air than a HKS GT2835. The 2835 uses a TO4S compressor housing, and this is where the clearance problems come from. There is more to sizing turbos than just buying something from HKS because it is said to be good. It is a good turbo, but with our limited clearance you have 2 choices, cut the frame, or get the same CHRA but assembled with a different housing.
Follow Ups	Any besides Pentroof for tubular ex. manifold for TT that - MikeH(Twin GT35BB Incon Z) 14:18:20 04/30/03 gregs manifolds should be done sometime soon right ? - Chris(NJ) 14:24:13 04/30/03 I spoke with Greg, he is working on Inconel version but - MikeH(Twin GT35BB Incon Z) 14:26:13 04/30/03 Inconel isn't cheap... or easy to weld... - MugenRacer 14:48:07 04/30/03 afterall, it's what the Mclaren F1 uses for exhaust manis :) (n/m) - degradated 20:30:18 04/30/03 Last I heard it would be about 6 months.. - degradated 20:32:40 04/30/03 Hold tight, We will be releasing a few new products after - Chip(GinnMotorsports) 14:53:46 04/30/03 Sign me up :) (n/m) - LRD VDR 14:56:23 04/30/03 Also, there will be 2 versions >> - Chip(GinnMotorsports) 15:04:28 04/30/03 Umm Wow. No notching the frame for Big turbos? (n/m) - MugenRacer 15:20:52 04/30/03 Notching the frame is 100% dependent on compressor housing - Chip(GinnMotorsports) 15:30:13 04/30/03 Chip, I had no idea you were working on one. If not SS then - MikeH(Twin GT35BB Incon Z) 15:45:02 04/30/03 This has been in the works for almost 2 years, ask Carlos R. - Chip(GinnMotorsports) 15:53:20 04/30/03 Since its been in the works for alomst 2 years I was - JMT-Z(St. Louis) 16:05:03 04/30/03 The manifold that was in the works has been flow tested - Chip(GinnMotorsports) 17:17:06 04/30/03 I didn't know you can weld on cast steel . Cast is cast in - MikeH(Twin GT35BB Incon Z) 16:09:38 04/30/03 Examples: - Chip(GinnMotorsports) 17:28:28 04/30/03 You're talking about - RSR 07:04:20 05/01/03 What gauge steel? Hopefully at least 14 gauge. - teahead 09:55:02 05/01/03
Post a Followup	You cannot reply to this message because you are not logged in.