Subject	We use 92mm pistons in our racecar. No Sleeves.
Posted by	Escort Z on April 29, 2003 at 7:48 PM
	This message has been viewed 207 times.
In Reply To	The stroker kit uses 92mm pistons and sleeves the block posted by Carlos Ramirez on April 29, 2003 at 07:33 PM
Message	Using standard size rods. Our compression ratio is 8.5:1. Total displacement comes out to about 3.2L.
Follow Ups	SGP is pushing the envelope with their 90mm pistons. - MikeH(Twin GT35BB Incon Z) 18:51:40 04/29/03 you can always get another fresh block, or resleeve yours. (n/m) - niXit 19:28:30 04/29/03 Yea...only 1 in 15 is good to bore to 90mm (n/m) - SteamyZ(ZtoyZ.NET) 23:26:43 04/29/03 The stroker kit uses 92mm pistons and sleeves the block - Carlos Ramirez 19:33:11 04/29/03 We use 92mm pistons in our racecar. No Sleeves. - Escort Z 19:48:54 04/29/03 on 30+psi too,,,,,lol. (n/m) - ZBlacktt 20:06:44 04/29/03 3311cc what it adds up to. - Carlos Ramirez 20:19:53 04/29/03 "80% of the blocks tested could not withstand ----> - Kyle(Houston) 21:30:02 04/29/03 Consider the source, JWT also said that 480BHP is the max - MikeH(Twin GT35BB Incon Z) 22:14:10 04/29/03 Well consider the source then - SteamyZ(ZtoyZ.NET) 23:28:19 04/29/03 NOT BS - SteamyZ(ZtoyZ.NET) 23:31:30 04/29/03 I am not saying that there are not blocks that have ---> - Kyle(Houston) 08:47:29 04/30/03 I am basically quoting MS. You can call and ask bro (n/m) - Carlos Ramirez 06:32:09 04/30/03 I know it wasn't your qoute but it is still BS ;-).......... (n/m) - Kyle(Houston) 08:43:18 04/30/03 contrary to popular opinion, you can go very large on the Z - NR98 (Ohio) 20:59:47 04/29/03 On a good block - SteamyZ(ZtoyZ.NET) 23:32:15 04/29/03 Have it magnufluxed and find out (n/m) - SteamyZ(ZtoyZ.NET) 23:26:15 04/29/03
Post a Followup	You cannot reply to this message because you are not logged in.