Subject	I wonder on if on hight boost turbo engines we should be
Posted by	MikeH(Twin GT35BB Incon Z) on April 28, 2003 at 12:58 AM
	This message has been viewed 92 times.
In Reply To	Looks like I got a spun rod bearing posted by MikeH(Twin GT35BB Incon Z) on April 28, 2003 at 12:08 AM
Message	running slightly looser rod clearance to get thicker film of oil? I hope metal shavings have not gone through the engine, oil pump, turbos.
Follow Ups	Looks like I got a spun rod bearing - MikeH(Twin GT35BB Incon Z) 00:08:16 04/28/03 eww...I hope that's not the case dude. - Spee 00:56:13 04/28/03 I wonder on if on hight boost turbo engines we should be - MikeH(Twin GT35BB Incon Z) 00:58:57 04/28/03 I doubt it when i spun a bearing, the noise is there - gtclk 02:16:53 04/28/03 when i spun mine, it was really only noticable - AntiHero[seatbelts rock] 09:30:28 04/28/03 We use looser clearance for high HP motors...... (n/m) - Kyle(Houston) 07:23:58 04/28/03 How loose? (n/m) - Ed(Toronto) 08:23:38 04/28/03 Heavier oil will help some. (n/m) - Chip(GinnMotorsports) 10:46:37 04/28/03 That sucks.....sorry to hear. (n/m) - BryZ32TT 08:03:51 04/28/03 So you were running 18 psi on pump gas? (n/m) - Seb 21:17:49 04/28/03 I alway run 18 psi on pump gas. That is not that much - MikeH(Twin GT35BB Incon Z) 21:48:36 04/28/03 That's too much on pump gas! I don't care if you have - Seb 00:46:20 04/29/03
Post a Followup	You cannot reply to this message because you are not logged in.