Subject	Looks like I got a spun rod bearing
Posted by	MikeH(Twin GT35BB Incon Z) on April 28, 2003 at 12:08 AM
	This message has been viewed 193 times.
Message	I was programming my Blitz boost controller and doing a run of 18 psi which I always do. Heard loud clatter. I hope my engine block is not damage or pistons. I will do a compression check. I am running stock bearings and probe H-beab rods. I started hearing faint rod knock at start up recently but goes a away after a few seconds when oil pressure builds up. My friend said he lost two rod bearings on his Supra because they were too tight. There not enough oil can get between the crank.
Follow Ups	Looks like I got a spun rod bearing - MikeH(Twin GT35BB Incon Z) 00:08:16 04/28/03 eww...I hope that's not the case dude. - Spee 00:56:13 04/28/03 I wonder on if on hight boost turbo engines we should be - MikeH(Twin GT35BB Incon Z) 00:58:57 04/28/03 I doubt it when i spun a bearing, the noise is there - gtclk 02:16:53 04/28/03 when i spun mine, it was really only noticable - AntiHero[seatbelts rock] 09:30:28 04/28/03 We use looser clearance for high HP motors...... (n/m) - Kyle(Houston) 07:23:58 04/28/03 How loose? (n/m) - Ed(Toronto) 08:23:38 04/28/03 Heavier oil will help some. (n/m) - Chip(GinnMotorsports) 10:46:37 04/28/03 That sucks.....sorry to hear. (n/m) - BryZ32TT 08:03:51 04/28/03 So you were running 18 psi on pump gas? (n/m) - Seb 21:17:49 04/28/03 I alway run 18 psi on pump gas. That is not that much - MikeH(Twin GT35BB Incon Z) 21:48:36 04/28/03 That's too much on pump gas! I don't care if you have - Seb 00:46:20 04/29/03
Post a Followup	You cannot reply to this message because you are not logged in.