Subject	new z32 owners requests help
Posted by	BROHAM108 on November 28, 2000 at 1:50 AM
	This message has been viewed 12 times.
Message	i just bought a '93 300tt about 2 weeks ago. im a new member of the 300 forum and i dont really know my way around. i've noticed that some have more mods then others and that you all know alot more than most people. well since i been on the forum i really dont know were to start. when you get a tt what is the first thing you would do? would you start with stuff like precautions or do you just go straight to the mods. i just bought and installed the a'pexi avcr and the super afc, but i'm leaning more towards a manual boost controller due to the boost spicks also i'm waiting for my fuel cut eliminator. i've noticed when i got my '93 rx-7 that the first thing that was recommended for the car was to tie wrap the vac. lines (all 80 some lines) and to replace the pre-cat with a down pipe. now its about 10 months later and about 2500 dollars later and at the dyno it put out 384.7 rear wheel hp and 367.9 lb-ft at 13 psi on pump gas. i would like to have someone to help me get this project started as i did with my rx-7. so if someone could e-mail me sometime it would be appreciated.
Follow Ups	new z32 owners requests help - BROHAM108 01:50:27 11/28/00 I think it would depend>> - BooZTT (Hawaii) 02:03:58 11/28/00 first thing, check your compression ratio b4 your project> - FLY 1 (DallaZ) 03:03:48 11/28/00
Post a Followup	You cannot reply to this message because you are not logged in.