Subject	I used a Dremel to cut the hose
Posted by	Marshall on April 08, 2003 at 1:52 PM
	This message has been viewed 43 times.
In Reply To	What a Nightmare! Change PCV Values... posted by Gizmo600R on April 08, 2003 at 12:43 PM
Message	Mine were rock hard, not flexible at all as rubber should be. I used a Dremel to cut through it.
Follow Ups	What a Nightmare! Change PCV Values... - Gizmo600R 12:43:41 04/08/03 you're suppossed to cut the hoses & use new ones. (n/m) - Carlos-91NA-2+2-5sp. 12:45:55 04/08/03 Finally - a moment of clarity. (n/m) - YugoBernie (NoVA) 13:07:59 04/08/03 wow (n/m) - Guapo 14:25:46 04/08/03 Mechanic rule . If rubber is is old and harded, cut it off - MikeH(Twin GT35BB Incon Z) 13:32:43 04/08/03 I used a Dremel to cut the hose - Marshall 13:52:37 04/08/03 Is it really that difficult? I wanted to change it myself .. - ZSPEC 14:11:13 04/08/03 not bad, get new valves & new hoses. need long - Carlos-91NA-2+2-5sp. 14:23:10 04/08/03 It's not *SO* hard. Just cramped and slow going. (n/m) - YugoBernie (NoVA) 14:31:21 04/08/03 no. Its about 45 minutes on an NA (n/m) - Guapo 14:47:59 04/08/03 Is it really that difficult? I wanted to change it myself .. - ZSPEC 14:44:11 04/08/03 no. Its about 45 minutes on an NA (n/m) - Guapo 14:48:14 04/08/03 should have just taken the plenum off... (n/m) - 3 double-0 ZX(Va Bch) 17:15:37 04/08/03
Post a Followup	You cannot reply to this message because you are not logged in.