Subject	There is only one solution....... >>>
Posted by	nissanzxman on April 01, 2003 at 7:22 AM
	This message has been viewed 37 times.
In Reply To	Please read the other post - I bent the dipstick tube, and posted by boileralum on March 31, 2003 at 10:57 PM
Message	Give me your motor. ;) But I agree with attempting to grind the tip flat or if possible remove it. As a very last resort you could cut off the tip of the stick, guarantee it will go in then, just won't be very accurate. ;) It can't be that hard to find the same diameter/type of metal used on the stock dipstick, cut to the same length, and then weld it to a handle. Put some marks on it for H and L and be good to go. My .02 Eric
Follow Ups	Update on my dipstick dilemna - boileralum 22:21:27 03/31/03 What's the matter with dude?>>> - nemesiZ(Dallas) 22:50:00 03/31/03 click the lazy link...the tube is blocked - outkaZTT 22:56:43 03/31/03 I don't think a different designed dipstick will be half- - boileralum 23:00:25 03/31/03 True, I hear ya (n/m) - outkaZTT 14:00:00 04/01/03 Please read the other post - I bent the dipstick tube, and - boileralum 22:57:42 03/31/03 Grind the tip flat. (n/m) - YugoBernie (NoVA) 23:06:40 03/31/03 There ya go! (n/m) - nemesiZ(Dallas) 23:11:19 03/31/03 I think it is still too long to make the bend. What's the - boileralum 23:15:43 03/31/03 New ones are cheap - < $25.00 (n/m) - YugoBernie (NoVA) 23:49:38 03/31/03 There is only one solution....... >>> - nissanzxman 07:22:48 04/01/03 Original post from technical as well - boileralum 23:04:49 03/31/03 Have you talked to a machine shop.... - OPTIMUSZ 08:27:25 04/01/03 I'll see what I can do for you Rich - govaardz(Aruba) 12:24:24 04/01/03 Thank you, I emailed you. (n/m) - boileralum 13:14:58 04/01/03
Post a Followup	You cannot reply to this message because you are not logged in.