| Message |
: back on yet? I dunno how, but Ben's just fit right on without any mods.
: : : Some people like the bend, others can't stand it... it's up to you. It usually comes in silver, but mine is the anodized blue "Concentration 20" bar. It's lightweight, one-piece aluminum (weighs less than 1.5 pounds). It's very easy to install... just the 2 nuts on each side. You may or may not need to grind the plastic throttle cable cover (or just remove it completely... only 4 bolts). Ben(Miami) didn't have to grind his plastic cover... it just fit right on. Anyways, I feel that grinding a decorative plastic cover is much better than grinding metal off something that's supposed to be providing structural support. Regardless, there are absolutely no hood rubbing issues because it fits nice and low thanks to it's wicked bends. As you can see in the bottom picture, the welds on the end pieces are extremely high quality. It's pricey though... $3-400 depending on shipping, exchange rate (must order from Japan), etc.
: : : 
: : : 
 |
 |
