Subject	Question for you about aquamist testing
Posted by	Chip(GinnMotorsports) on March 18, 2003 at 3:25 PM
	This message has been viewed 27 times.
In Reply To	RE: analysis, posted by niXit on March 18, 2003 at 01:45 PM
Message	what boost level were you running when you measured the intake temps? I have temp sensors mounted right in front of my TBs, and I am trying to compare. That may be impossible since your sensors were after the TB.
Follow Ups	Is it more feasable to put a water mist injection before or - Milo (San Antonio, TX.) 10:17:09 03/18/03 FWIW; Aquamist GB is on permanent hold. - niXit 10:25:19 03/18/03 Thanx for the FYI, nixit. (n/m) - Milo (San Antonio, TX.) 10:28:53 03/18/03 Its gonna be specific to the vehicle. - AshsZ (FabZEM All) 11:03:07 03/18/03 Thermodynamic transfer rate is higher as the difference - AshsZ (FabZEM All) 10:54:20 03/18/03 SEE, that is the way I was thinking (ie- injection right - Milo (San Antonio, TX.) 11:31:54 03/18/03 Re: Thermodynamic transfer rate is higher as the difference - niXit 11:59:36 03/18/03 Devil's Advocate: You will decrease the flow through - Chip(GinnMotorsports) 12:34:21 03/18/03 But the hot water will transfer more of the heat to - AshsZ (FabZEM All) 14:18:29 03/18/03 So you think that more than makes up for the restriction? - Chip(GinnMotorsports) 15:22:59 03/18/03 If I had a thermo book handy, I would model the system - BigTDogg (BOOST-GASM!!!!!) 13:11:45 03/18/03 RE: analysis, - niXit 13:45:00 03/18/03 Agree 100% - RSR 13:54:54 03/18/03 True, and like Nixit said, there are many unknowns.. - BigTDogg (BOOST-GASM!!!!!) 14:06:36 03/18/03 However, that info could be easily collected with the - AshsZ (FabZEM All) 14:23:47 03/18/03 I have 16 channels of A-D I could employ to do this. - AshsZ (FabZEM All) 14:22:07 03/18/03 Question for you about aquamist testing - Chip(GinnMotorsports) 15:25:44 03/18/03 Empirical testing hands Sir. Theory his arse. :) (n/m) - AshsZ (FabZEM All) 14:24:31 03/18/03 I would be worried about the water falling - RSR 13:20:25 03/18/03 My biggest concern would be the corrosion of the IC's. - AshsZ (FabZEM All) 14:26:23 03/18/03 Good point. (n/m) - Milo (San Antonio, TX.) 15:14:47 03/18/03 After reading all the posts, I'm left with one thought.. - -Ever- 18:11:50 03/18/03
Post a Followup	You cannot reply to this message because you are not logged in.