Subject	I'll make some measurements for you tomorrow when I go
Posted by	boileralum00 on March 14, 2003 at 3:48 PM
	This message has been viewed 25 times.
In Reply To	If you could get a measurement of the gap between the posted by AshsZ (FABio) on March 14, 2003 at 03:09 PM
Message	to the garage to work on her. Rule #1 - There's always a bastard!
Follow Ups	Need some help, hope someone has a pic. >>> - AshsZ (FABio) 14:06:38 03/14/03 Bah, Type 03s are overrated! - boileralum00 14:14:14 03/14/03 Compare the offsets, how much difference? Don't believe the - Milo (San Antonio, TX.) 14:16:04 03/14/03 What is the clearance between the back of the 'spokes' - AshsZ (FABio) 14:19:47 03/14/03 this may be too obvious, but - Marshall 14:25:56 03/14/03 Captain Obvious may ring in on this, and it does seem - AshsZ (FABio) 14:32:38 03/14/03 I dunno how relevant it is, but on my 18s there isn't a - boileralum00 14:48:54 03/14/03 That inner ridge where the center attaches to the wheel - AshsZ (FABio) 14:53:25 03/14/03 Yes, mine are 18". I'd think you could sell the 17s fairly - boileralum00 14:59:05 03/14/03 If you could get a measurement of the gap between the - AshsZ (FABio) 15:09:59 03/14/03 I'll make some measurements for you tomorrow when I go - boileralum00 15:48:18 03/14/03 Much appreciated bro! (n/m) - AshsZ (FabZEM All) 20:55:10 03/14/03 Blitz does not make a 17X9 that clears STOCK brakes - Chip(GinnMotorsports) 15:37:48 03/14/03 Interesting. What has to be done to make them fit? (n/m) - AshsZ (FABio) 15:51:42 03/14/03 Big spacer, they are not a high disk design. (n/m) - Chip(GinnMotorsports) 09:43:33 03/15/03 im sure they will fit, i have 13 inch rotors on my car with - gtclk 16:40:02 03/14/03 His problem is very odd offset because of custom rotors. (n/m) - YugoBernie (NoVA) 09:40:44 03/15/03 Why didn't U get 18x9s? At any rate, 03s sweet upgrade - teahead 21:15:24 03/14/03
Post a Followup	You cannot reply to this message because you are not logged in.