Subject	If you could get a measurement of the gap between the
Posted by	AshsZ (FABio) on March 14, 2003 at 3:09 PM
	This message has been viewed 36 times.
In Reply To	Yes, mine are 18". I'd think you could sell the 17s fairly posted by boileralum00 on March 14, 2003 at 02:59 PM
Message	face of the caliper where it says "NISSAN" and the back of the spoke at the closest point, that would be great. If you can also measure the gap between the outer part of the caliper(furthest radius) to the inside diameter of the wheel, that would be great. I'm hoping you will find at least 3/8" (9.53mm) gap between the face and back of spoke and since you have 18" wheels, I'm hoping you will find a little better than 2.5 inches between the i.d. of the wheel and the outer part of the caliper. If you could check this out, I'd be very greatful. [ ashleypowers.com ] [ agpowers@bellsouth.net ] [ Zemulator Information Sheet ] Enthusiasts soon understand each other. --W. Irving. Are you an enthusiast?
Follow Ups	Need some help, hope someone has a pic. >>> - AshsZ (FABio) 14:06:38 03/14/03 Bah, Type 03s are overrated! - boileralum00 14:14:14 03/14/03 Compare the offsets, how much difference? Don't believe the - Milo (San Antonio, TX.) 14:16:04 03/14/03 What is the clearance between the back of the 'spokes' - AshsZ (FABio) 14:19:47 03/14/03 this may be too obvious, but - Marshall 14:25:56 03/14/03 Captain Obvious may ring in on this, and it does seem - AshsZ (FABio) 14:32:38 03/14/03 I dunno how relevant it is, but on my 18s there isn't a - boileralum00 14:48:54 03/14/03 That inner ridge where the center attaches to the wheel - AshsZ (FABio) 14:53:25 03/14/03 Yes, mine are 18". I'd think you could sell the 17s fairly - boileralum00 14:59:05 03/14/03 If you could get a measurement of the gap between the - AshsZ (FABio) 15:09:59 03/14/03 I'll make some measurements for you tomorrow when I go - boileralum00 15:48:18 03/14/03 Much appreciated bro! (n/m) - AshsZ (FabZEM All) 20:55:10 03/14/03 Blitz does not make a 17X9 that clears STOCK brakes - Chip(GinnMotorsports) 15:37:48 03/14/03 Interesting. What has to be done to make them fit? (n/m) - AshsZ (FABio) 15:51:42 03/14/03 Big spacer, they are not a high disk design. (n/m) - Chip(GinnMotorsports) 09:43:33 03/15/03 im sure they will fit, i have 13 inch rotors on my car with - gtclk 16:40:02 03/14/03 His problem is very odd offset because of custom rotors. (n/m) - YugoBernie (NoVA) 09:40:44 03/15/03 Why didn't U get 18x9s? At any rate, 03s sweet upgrade - teahead 21:15:24 03/14/03
Post a Followup	You cannot reply to this message because you are not logged in.