Subject	just out of observation too, most people that claim to
Posted by	z324u on March 06, 2003 at 11:04 PM
	This message has been viewed 127 times.
In Reply To	This is what a shitty cylinder hone job looks like posted by MikeH(Twin GT35BB Incon Z) on March 06, 2003 at 10:48 PM
Message	have a problem with the wiseco pistons making noise at certian loads (like what this person was discussing in tech the other day) are running the stock rods, and people that dont have a problem with them like me, are running aftermarket rods. i wonder if it has something to do with the pins that come with those pistons, and the bearing diameter of the stock rods vs. aftermarket? i cant seem to find the inner diameter of the eagle/pauter bearings vs. stock anywhere. yeah thats a crappy hone job though. there is hole in the wall machine shop down the street that does a whole lot better job than that for 50$
Follow Ups	This is what a shitty cylinder hone job looks like - MikeH(Twin GT35BB Incon Z) 22:48:12 03/06/03 just out of observation too, most people that claim to - z324u 23:04:29 03/06/03 Good 'ol floating wrist pins eh? (n/m) - boostle 23:09:41 03/06/03 thats what i was thinking, but i could be wrong (n/m) - z324u 23:31:27 03/06/03 Re: This is what a shitty cylinder hone job looks like - boostle 23:08:12 03/06/03 The cross-hatch was the honing job. Possible too tight - MikeH(Twin GT35BB Incon Z) 23:22:28 03/06/03 This is what it should look like if using the tried and true - MikeH(Twin GT35BB Incon Z) 23:30:42 03/06/03 wtf?? looks like he just used a dremel on it or something (n/m) - zads 02:37:19 03/07/03 Re: This is what a shitty cylinder hone job looks like - fdaa 03:32:56 03/07/03
Post a Followup	You cannot reply to this message because you are not logged in.