Subject	This is what a shitty cylinder hone job looks like
Posted by	MikeH(Twin GT35BB Incon Z) on March 06, 2003 at 10:48 PM
	This message has been viewed 345 times.
Message	in a Z block. A z'er engine after 125 miles. Looks like the machinist didn't use a fine stone to do a plateua hone . If you can see the hatches with a camera picture. Imagine what it looks like in person. [ http://mwsmith.crosswinds.net/Engine%20damage/EngineDamage.html ]
Follow Ups	This is what a shitty cylinder hone job looks like - MikeH(Twin GT35BB Incon Z) 22:48:12 03/06/03 just out of observation too, most people that claim to - z324u 23:04:29 03/06/03 Good 'ol floating wrist pins eh? (n/m) - boostle 23:09:41 03/06/03 thats what i was thinking, but i could be wrong (n/m) - z324u 23:31:27 03/06/03 Re: This is what a shitty cylinder hone job looks like - boostle 23:08:12 03/06/03 The cross-hatch was the honing job. Possible too tight - MikeH(Twin GT35BB Incon Z) 23:22:28 03/06/03 This is what it should look like if using the tried and true - MikeH(Twin GT35BB Incon Z) 23:30:42 03/06/03 wtf?? looks like he just used a dremel on it or something (n/m) - zads 02:37:19 03/07/03 Re: This is what a shitty cylinder hone job looks like - fdaa 03:32:56 03/07/03
Post a Followup	You cannot reply to this message because you are not logged in.