Subject	Whoever "someone" was, is right>>
Posted by	JRH(KY) on March 04, 2003 at 9:48 AM
	This message has been viewed 51 times.
In Reply To	Question in regards to OEM fascia>> posted by dilly yo on March 04, 2003 at 09:31 AM
Message	If it was a new urethane fascia it needs to first be thoroughly cleaned to remove any release agents left over from the manufacturing process. This will cause paint to flake. A flex agent is also a must when painting urethane. Go back to who painted it and tell them to do it right. _________________________________________________ Jonathan Howlett AIM-JRHZ32 1993 Ultra Red Twin Turbo 1990 Pearl Yellow Twin Turbo(Deceased)
Follow Ups	Question in regards to OEM fascia>> - dilly yo 09:31:38 03/04/03 Whoever "someone" was, is right>> - JRH(KY) 09:48:05 03/04/03 The piece should be prepped before painting in the - Milo (San Antonio, TX.) 10:01:45 03/04/03 Sounds like lack of sanding and chemical prep. (n/m) - YugoBernie (NoVA) 11:09:18 03/04/03 the plastic wasn't prepped well - ZEngineer 11:37:18 03/04/03
Post a Followup	You cannot reply to this message because you are not logged in.