Subject	two car garage...but i dont have many tools >>
Posted by	genic on November 20, 2000 at 3:29 PM
	This message has been viewed 13 times.
In Reply To	don't suppose you have a place to work on a Z, do ya?>>> posted by my91z(D-town) on November 20, 2000 at 02:57 PM
Message	if you want to work on it there....more than happy to let you. just shares the garage with my cousins c5..hehe. email me if you want my pop up books didnt teach my puncuation or how to speel..soory :) -----
Follow Ups	"General" question on rounded off nuts>>>> - my91z(D-town) 13:51:21 11/20/00 You might try carefully drilling down each side of the nut=> - Whisper 13:57:25 11/20/00 what mechanics sometimes do when they encounter a rounded--> - TRUOMEGA 14:04:36 11/20/00 also..i have seen this done >> - genic 14:21:15 11/20/00 I tried beating a smaller socket onto it before I rounded>> - my91z(D-town) 14:29:52 11/20/00 if all of that doesnt work...small explosives might :) - genic 14:39:37 11/20/00 you could always use a dremel with a heavy duty cutting disc - Bernie 14:35:02 11/20/00 just be careful not to go too far, otherwise you might - Bernie 14:36:10 11/20/00 I called Vince, bolt is chump-change, not worried about>> - my91z(D-town) 14:38:57 11/20/00 i have a dremel if you need one (n/m) - genic 14:40:25 11/20/00 don't suppose you have a place to work on a Z, do ya?>>> - my91z(D-town) 14:57:39 11/20/00 two car garage...but i dont have many tools >> - genic 15:29:05 11/20/00 check your email. (n/m) - my91z(D-town) 16:12:56 11/20/00 dremels are pretty cheap too... about $40... it's a really - Bernie 14:48:23 11/20/00 similar experience for me, but cut the nut parallel - toyluvr 20:14:30 11/20/00 Thanks Admin :) (n/m) - my91z(D-town) 15:49:49 11/20/00
Post a Followup	You cannot reply to this message because you are not logged in.