Subject	Details >>
Posted by	Chip(GinnMotorsports) on February 24, 2003 at 12:56 PM
	This message has been viewed 95 times.
In Reply To	Close up picture of a dual POP elbows?? posted by TARGETZ on February 24, 2003 at 12:45 PM
Message	about 120 degree, VERY tigt radius (cast aliminum), 2.5" on car piping end, ~3" on MAS end. Cheapest thing to do is buy 2 120 degree 2.5" pipes (Apex makes cast tight radius elbows. Buy 2 2.5"->3" reducers, and either another MAS, or fad a 3-4" (same length as MAS) 3" pipe with a flange welded on the end that matches the MAS bolt pattern.
Follow Ups	Close up picture of a dual POP elbows?? - TARGETZ 12:45:44 02/24/03 Details >> - Chip(GinnMotorsports) 12:56:15 02/24/03 Re: Details >> - 300zxracing91 13:14:47 02/24/03 Personally, I would wait until bigger turbos - Chip(GinnMotorsports) 14:44:56 02/24/03 Or I found a place that will make them for $100. - Woody75 (Denver) 14:11:50 02/24/03 here are pics> - Wagz 13:12:14 02/24/03 Dont just hate those Apexi adjustment nuts? ( Rust ) :( (n/m) - ZBlacktt 14:53:50 02/24/03 Pic inside..... - Wui (Philly) 14:04:46 02/24/03 Why does that look so not worth the money? ,,lol ;)~ (n/m) - ZBlacktt 14:55:13 02/24/03 it's not worth the money, but we will buy it! sad it is!! (n/m) - serge968 15:55:19 02/24/03 i am getting mine tomorrow!! yeah-whoo hooo! (n/m) - serge968 15:51:14 02/24/03
Post a Followup	You cannot reply to this message because you are not logged in.