Subject	Pilers and a flat tip screw driver.
Posted by	ZBlacktt on February 08, 2003 at 6:53 PM
	This message has been viewed 56 times.
In Reply To	boost jet install posted by holcomb74 on February 08, 2003 at 03:53 PM
Message	Sure you got all four intake hose's off. Just pinch the metal fastener with the pliers and take the flat tip screw driver and push the fastener back down ( away ) from the end of hose your pulling off. Then do the same with the pliers by garbing and holding the rubber line and slightly pull back while taking that flat tip screw driver and placing it between the metal pipe and end of the rubber line pushing the rubber line back off it's connection, like prying it back at the same time. Because if you just pull it with the pliers, the rubber line actually grabs harder to it's connection point. Just pry the line off. STAGE V++++ Going to XV+ and beyond :) Yellow Z STAGE II Going to XI+
Follow Ups	boost jet install - holcomb74 15:53:51 02/08/03 a pair of 11" bent nosed pliers goes a long way here. - sbsTT(MD) 16:16:43 02/08/03 A big TEN FOUR on the long, curved, needle nose pliers. >> - sebring1970 (robo) 16:53:34 02/08/03 This tool is almost mandatory to work on the Z - jayZbird 00:01:17 02/09/03 Re: a pair of 11" bent nosed pliers goes a long way here. - holcomb74 17:35:33 02/08/03 Sears has 'em, sometimes. I found a no-name brand at an - sebring1970 (robo) 17:45:07 02/08/03 nope, nothing special about them, you can get them - sbsTT(MD) 17:55:23 02/08/03 Pilers and a flat tip screw driver. - ZBlacktt 18:53:12 02/08/03
Post a Followup	You cannot reply to this message because you are not logged in.