Subject	boost jet install
Posted by	holcomb74 on February 08, 2003 at 3:53 PM
	This message has been viewed 173 times.
Message	HELP!!! I have spent the last two hours trying to get the waste gate vacuum lines off. I am not a big guy, 5'10, but have big hands and can't get a pair of pliers in there. I am pretty sure, from the FAQ and other tt.net sources that I have the right lines, but is there a special tool you would recommend to use to: 1) Get the metal fasteners off (esp the pass side, where the clamp is facing straight down. 2) Get the hoses off the tubes themselves. I know lots of guys have done the install, what am I doing wrong??? Thanks, Mike
Follow Ups	boost jet install - holcomb74 15:53:51 02/08/03 a pair of 11" bent nosed pliers goes a long way here. - sbsTT(MD) 16:16:43 02/08/03 A big TEN FOUR on the long, curved, needle nose pliers. >> - sebring1970 (robo) 16:53:34 02/08/03 This tool is almost mandatory to work on the Z - jayZbird 00:01:17 02/09/03 Re: a pair of 11" bent nosed pliers goes a long way here. - holcomb74 17:35:33 02/08/03 Sears has 'em, sometimes. I found a no-name brand at an - sebring1970 (robo) 17:45:07 02/08/03 nope, nothing special about them, you can get them - sbsTT(MD) 17:55:23 02/08/03 Pilers and a flat tip screw driver. - ZBlacktt 18:53:12 02/08/03
Post a Followup	You cannot reply to this message because you are not logged in.