Subject	you need a tight bend radius pipe
Posted by	Marshall on February 07, 2003 at 12:57 AM
	This message has been viewed 42 times.
In Reply To	Building Twin Pop Questions posted by EricTTZ on February 06, 2003 at 10:06 PM
Message	I'm not sure if the ones at JC Whitney will work. I haven't tried to use them, but I researched it before and the bend isn't as tight as the JWT ones are. Maybe you can bend the intakes in a little if you can't get the right size bend. About that piece that goes in place of the MAF on the other side, you can just make it. That's what I'm going to do. Make a flange and weld it to a pipe. For me the welding would be the hard part, but the flange is the easy part.
Follow Ups	Building Twin Pop Questions - EricTTZ 22:06:04 02/06/03 damn those rims look sweet on your Z - TARGETZ 22:10:35 02/06/03 cool website - SlidewaysZ 22:10:38 02/06/03 Thanks - EricTTZ 22:14:35 02/06/03 You'll have to get it custom fabbed - JWT won't sell it - YugoBernie (NoVA) 22:18:11 02/06/03 Re: Building Twin Pop Questions - rodelb 22:18:33 02/06/03 how wide are your back tires? and the offset? (n/m) - taco82xx 22:54:30 02/06/03 did u custom build the piping? (n/m) - aliaZ 23:48:27 02/06/03 you need a tight bend radius pipe - Marshall 00:57:45 02/07/03 you will need casted elbows to make those turns. - Carlos Ramirez 06:13:49 02/07/03 Or you could do this >> - Turbodog (CT) 06:42:33 02/07/03 Pics didn't post Turbodog (n/m) - CreativeZ 08:54:52 02/07/03 you can get elbows here--------------------------->> - jamcru 09:09:31 02/07/03 Just an fyi - Xi0nX4 (ohio) 10:42:36 02/07/03 I saw the dyno your talking about - EricTTZ 13:36:28 02/07/03 I see. Yeah, probally a good idea to do both at the same> - Xi0nX4 (ohio) 17:18:37 02/07/03
Post a Followup	You cannot reply to this message because you are not logged in.