Subject	Building Twin Pop Questions
Posted by	EricTTZ on February 06, 2003 at 10:06 PM
	This message has been viewed 428 times.
Message	I'm looking to build a twin pop at the same time I upgrade my ECU with my injectors. Where can I find the piece of metal on the left that bolts into the pop charger if I end up doing a single MAF setup? like the one below... Also do these look like the right mandrel bend pipes to use? $10 each Then all I would need left is: 1) a second JWT pop charger $85 2) 4 silicone conectors $? 3) 8 clamps $16? AIM: EricTTZ
Follow Ups	Building Twin Pop Questions - EricTTZ 22:06:04 02/06/03 damn those rims look sweet on your Z - TARGETZ 22:10:35 02/06/03 cool website - SlidewaysZ 22:10:38 02/06/03 Thanks - EricTTZ 22:14:35 02/06/03 You'll have to get it custom fabbed - JWT won't sell it - YugoBernie (NoVA) 22:18:11 02/06/03 Re: Building Twin Pop Questions - rodelb 22:18:33 02/06/03 how wide are your back tires? and the offset? (n/m) - taco82xx 22:54:30 02/06/03 did u custom build the piping? (n/m) - aliaZ 23:48:27 02/06/03 you need a tight bend radius pipe - Marshall 00:57:45 02/07/03 you will need casted elbows to make those turns. - Carlos Ramirez 06:13:49 02/07/03 Or you could do this >> - Turbodog (CT) 06:42:33 02/07/03 Pics didn't post Turbodog (n/m) - CreativeZ 08:54:52 02/07/03 you can get elbows here--------------------------->> - jamcru 09:09:31 02/07/03 Just an fyi - Xi0nX4 (ohio) 10:42:36 02/07/03 I saw the dyno your talking about - EricTTZ 13:36:28 02/07/03 I see. Yeah, probally a good idea to do both at the same> - Xi0nX4 (ohio) 17:18:37 02/07/03
Post a Followup	You cannot reply to this message because you are not logged in.