TwinTurbo.NET: Nissan 300ZX forum - not really, but it doesn't directly screw on like razo's
People Seeking Info
 
   


     
Subject not really, but it doesn't directly screw on like razo's
     
Posted by Midnight4 on January 30, 2003 at 12:36 PM
  This message has been viewed 75 times.
     
In Reply To Did you do any mods to get it to fit? (n/m) posted by BrianTT(TPA,FL) on January 30, 2003 at 12:12 PM
     
Message There are 3 screws provided that go to the bottom part of the shift knob. These 3 screws clamp on the side of the shifter so the knob doesn't move. They may come loose if you twist the shift knob a lot while you shift, but I screw them on real tight, so it's not a problem to me.

Since the stock shift boot sits kinda low to accomodate the stock shift knob, I made a little ring to hold the top of the boot higher, so it reaches the bottom of the shift knob. I think oppamanZ gives you this aftermarket shift knob adaptor if you buy shift boots from him.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.