Subject	If you have a die grinder/air compressor:
Posted by	therinL on January 29, 2003 at 4:43 PM
	This message has been viewed 74 times.
In Reply To	HKS 2530 Lag solution??? posted by Otamann on January 29, 2003 at 04:23 PM
Message	You could port match everything and port out the runners a bit. Im not sure how thick it is or how big you want to go, but port matching/porting should help substantially and would save alot of money. Im all about saving money =) Later Josh
Follow Ups	HKS 2530 Lag solution??? - Otamann 16:23:54 01/29/03 sounds good to me,hell buy two while youre at it..... (n/m) - JMT-Z(St. Louis) 16:30:47 01/29/03 Definately not lag free, but it would help a lot - U ZCREAM (TTZ in '03) 16:33:50 01/29/03 what do you know..you drive a van (n/m) - genic 16:39:41 01/29/03 yea but I can read (n/m) - U ZCREAM (TTZ in '03) 16:42:07 01/29/03 so can i, but that doesnt make me smart (n/m) - genic 16:49:40 01/29/03 liar, I know your gimp reads for you - U ZCREAM (TTZ in '03) 16:57:20 01/29/03 stock manifolds cracking? very rare (n/m) - aliaZ 17:11:59 01/29/03 Re: stock manifolds cracking? very rare - U ZCREAM (TTZ in '03) 17:16:33 01/29/03 that was referring to the Greddy manifolds, not stockers (n/m) - aliaZ 18:00:14 01/29/03 If you have a die grinder/air compressor: - therinL 16:43:28 01/29/03 I have the 2530's - Z-king 17:45:00 01/29/03 To Z-king - Otamann 03:00:15 01/30/03 Get better Cams (n/m) - Flycaz 18:14:42 01/29/03 Buy JWT 535 BB Turbos :-) (n/m) - Coz@CZP 18:47:15 01/29/03 Yes it will spool faster with a good manifold. (n/m) - Chip(GinnMotorsports) 19:24:56 01/29/03
Post a Followup	You cannot reply to this message because you are not logged in.