TwinTurbo.NET: Nissan 300ZX forum - you have to get to the short 3" hose up front.
Subject
you have to get to the short 3" hose up front.
Posted by
niXit(StLouis)
on January 27, 2003 at 10:31 AM
This message has been viewed
39
times.
In Reply To
Why not just by-pass the stock fuel rail
posted by Atti2de
on January 27, 2003 at 10:27 AM
Message
with the plenum there, it's almost 100% impossible to get to. I've tried. And I have skinny little girl fingers.
Follow Ups
What exactly do I need for braided fuel lines (length, conne
-
Iced Z
09:53:45 01/27/03
are you really going to pull the plenum for that? goodness! (n/m)
-
niXit(StLouis)
10:09:49 01/27/03
I tired of breaking out the screw driver every cold morning
-
Iced Z
10:15:02 01/27/03
sounds like a lot of labor.
-
niXit(StLouis)
10:17:34 01/27/03
Why not just by-pass the stock fuel rail
-
Atti2de
10:27:26 01/27/03
you have to get to the short 3" hose up front. -
niXit(StLouis)
10:31:20 01/27/03
Oops, did not know that was the hose he was asking
-
Atti2de
10:34:29 01/27/03
The short hose seems most prone to leaking. (n/m)
-
niXit(StLouis)
10:55:35 01/27/03
you can not use generic high pressure line
-
down5hift
14:49:49 01/27/03
yes, I am very aware.
-
niXit
15:27:31 01/27/03
fuel injector hose from Salvo works fine for me. (n/m)
-
sbsTT(MD)
18:32:48 01/27/03
Loctite or double nut
-
goixiz
10:18:49 01/27/03
Yea, I don't smell anything after I tighten them also w/ loc
-
Iced Z
10:20:48 01/27/03
the clamps get worn, old, and brittle.
-
niXit(StLouis)
10:30:01 01/27/03
new clamps. Nissan OEM ones suck. (n/m)
-
sbsTT(MD)
18:29:58 01/27/03
How does every1 else do it. Seedy has em, Pats300zx has the
-
Iced Z
10:30:16 01/27/03
Unless you have AN fittings, braided lines won't do much. (n/m)
-
MikeH(Twin GT35BB Incon Z)
11:14:44 01/27/03
I've been looking into this as well, and I found a new part
-
boileralum00
15:49:57 01/27/03
hmmm...wonder if that is a new one that summit carries.
-
sbsTT(MD)
18:44:41 01/27/03
I hadn't seen it before today either, Spee. I actually saw
-
boileralum00
20:11:36 01/27/03
Post a
Followup
You cannot reply to this message because you are not
logged in
.