Subject	Re: I dont know alot about brands but:
Posted by	Mongoose on January 21, 2003 at 12:01 PM
	This message has been viewed 49 times.
In Reply To	I dont know alot about brands but: posted by therinL on January 21, 2003 at 11:20 AM
Message	Physics w/out Engineering is just Math (read Mental Masturbation) If you wanted to optimize the available surface area for a given _volume_, then yes a cube is your best answer. But would it make a good intercooler? No, because you generally only have airflow from one direction inside the car. So a flat plate is your best use of limited volume to maximize _useable_ surface area. I hate math :P
Follow Ups	Intercooler debate.......Which is best? - Shift_ 09:24:18 01/21/03 Do a search for my comparison pics of Stillen and Greddy - Woody75 (Denver) 09:30:44 01/21/03 The real debate on intercoolers is the frount mount VS - Milo (San Antonio, TX.) 09:32:02 01/21/03 I also posted some intercooler data a while back. Stillen vs - Scotts94z32 09:46:37 01/21/03 Did anyone ever get Powerups side mounts on that GB? (n/m) - Milo (San Antonio, TX.) 09:48:11 01/21/03 I dont know alot about brands but: - therinL 11:20:22 01/21/03 Re: I dont know alot about brands but: - Mongoose 12:01:16 01/21/03 Re: Re: I dont know alot about brands but: - therinL 12:17:57 01/21/03 The sides are a poor heat exchanger, might as well forget - Chip(GinnMotorsports) 12:25:34 01/21/03 That is not good, only one side gets ambient airflow - Chip(GinnMotorsports) 12:23:02 01/21/03 ditto. (n/m) - Scotts94z32 13:35:46 01/21/03 thanks for the input guys, ill search again (n/m) - Shift_ 12:24:59 01/21/03
Post a Followup	You cannot reply to this message because you are not logged in.