Subject	Would prefer 2-pc large, alum d/s, forgot where I saw it. (n/m)
Posted by	quikz on January 17, 2003 at 7:44 PM
	This message has been viewed 32 times.
In Reply To	Anyone have a one piece driveshaft on their 1990 Z? posted by Sh0wty on January 17, 2003 at 06:16 PM
Message
Follow Ups	Anyone have a one piece driveshaft on their 1990 Z? - Sh0wty 18:16:28 01/17/03 i have their 1 peice aluminum on my 90tt - Wagz 18:18:40 01/17/03 I have a carbonfiber 1 peice on my 95 (n/m) - Good2Zya 18:28:29 01/17/03 Had a one piece, but was way out of balance, I returned it. (n/m) - TwinTurboPoweredZ 18:47:10 01/17/03 I've got the one piece carbon fiber PST shaft on my 90 (n/m) - Toso 18:53:27 01/17/03 That applies to the steel driveshaft, BUT I believe that - Chip(GinnMotorsports) 18:54:21 01/17/03 Re: Anyone have a one piece driveshaft on their 1990 Z? - turbo-max 18:58:01 01/17/03 What is the advantage other than weight? (n/m) - MoshluB 19:05:56 01/17/03 less rotational mass... just like a lightened flywheel (n/m) - 3 double-0 ZX(Va Bch) 19:25:22 01/17/03 and it also takes the center pivot out (n/m) - 3 double-0 ZX(Va Bch) 19:26:02 01/17/03 Re: less rotational mass... just like a lightened flywheel.. - turbo-max 10:31:50 01/18/03 I ordered a Steel One Piece. - Sh0wty 19:08:30 01/17/03 sig test - Sh0wty 19:33:19 01/17/03 Would prefer 2-pc large, alum d/s, forgot where I saw it. (n/m) - quikz 19:44:02 01/17/03 Re: Anyone have a one piece driveshaft on their 1990 Z? - HOBIGD 20:36:18 01/17/03 I have ACPT Carbon Fiber Drive Shaft. Love it - Boosted1 21:15:36 01/17/03
Post a Followup	You cannot reply to this message because you are not logged in.