Subject	Couldn't tell by looking at them. But when they were
Posted by	AshsZ (FABio) on January 13, 2003 at 3:01 PM
	This message has been viewed 47 times.
In Reply To	Damn that piston took a beating. How did the valves look? (n/m) posted by Milo (San Antonio, TX.) on January 13, 2003 at 02:57 PM
Message	seated to the valve seat, you could see a faint line of light coming through a very small gap. You can't bent valves back so...... :) BTW, the name of those images is pistonbeat1.JPG and pistonbeat2.JPG. LOL They were beat so badly that the upper ring was pinched in its seat - it no longer freely floated like it is supposed to. [ ashleypowers.com ] [ agpowers@bellsouth.net ] [ Zemulator Information Sheet ] When pigs dance, you better get it on video... "You never really learn to swear until you learn to drive." -George Carlin
Follow Ups	Rod bearing replacement this weekend >>> - AshsZ (FABio) 14:26:22 01/13/03 Was the beer good? :) Thanx - that's a nice write-up (n/m) - sasha 14:44:17 01/13/03 For a Bud Light, it was refreshing. I would have preferred - AshsZ (FABio) 14:48:04 01/13/03 Newcastle (n/m) - Keith58 14:55:58 01/13/03 Damn that piston took a beating. How did the valves look? (n/m) - Milo (San Antonio, TX.) 14:57:12 01/13/03 Couldn't tell by looking at them. But when they were - AshsZ (FABio) 15:01:54 01/13/03 Ouch that sux - U ZCREAM (TTZ in '03) 14:59:09 01/13/03 The rings were pinched on that piston. They no longer - AshsZ (FABio) 15:03:43 01/13/03 Where's a "Master of the Obvious" pic when you need one :-) (n/m) - U ZCREAM (TTZ in '03) 15:37:52 01/13/03 I had to convince him that it needed to be replaced.> - AshsZ (FABio) 07:46:31 01/14/03 How do you like the new sway bars? (n/m) - hoss 15:47:29 01/13/03 Sway bars IMO are highly recommended. Even with my KYB's at - AshsZ (FABio) 17:30:16 01/13/03 Awesome--U_DA_MAN! hey put write-up in FAQ's - mossyoak 17:20:44 01/13/03
Post a Followup	You cannot reply to this message because you are not logged in.