 |
   |
|
| |
|
|
| Subject |
Have very good customer service, agreed. But there R&D |
|
| |
|
|
| Posted by |
Milo (San Antonio, TX.) on January 06, 2003 at 2:24 PM |
|
| |
This message has been viewed 36 times. |
|
| |
|
|
| In Reply To |
Have used Haltec, Motec, and AEM. posted by Carlos Ramirez on January 06, 2003 at 01:35 PM |
|
| |
|
|
| Message |
is good yet lacking. Take for example that "intake bypass" crap they sold for most intakes that had little plastic tabs that would let out drops of water if water ever got sucked into the intake, those little tabs of plastic broke off the piece and got sucked into the engine causic them to melt to the top of the pistons. On their first pulleys the metal they used was inferior and began to become out of balance. I've seen both of these product cause a lot of problems in the past, that is why I never really liked the company. You would figure for a company distributing that much product line they would have done a lot more R&D. But, again those were mistakes done when they were still a smaller business. I personally like the AEM fuel managment systems for the Honda but I would be rather leary of putting one in my Z. I would feel better once I knew someone had one and didn't have many gremlins. Just my opinion, though.
   |
|
| |
|
|
| Follow Ups |
|
|
| |
|
|
Post a
Followup |
You cannot reply to this message because you are not logged in.
|
|
| |
|
|
| |
|
|
|
11:04:33 01/06/03
