Subject	More info on my dyno when I had SP 500s
Posted by	Seb on January 05, 2003 at 3:42 PM
	This message has been viewed 264 times.
Message	We had our very first set of our prototype headers in the car. The Sport 500s holding only 19psi and dropping off to almost 17 psi in the dyno. I was also running only a single POP. We tore down the engine less than a month later, and found that pistons #2 & #4 had damaged ring lands. Pulling the pistons out and having piston material come out was a shock. It would have been very interesting to see what the same setup would have done with a good engine and the new Blitz boost controller. Damn the Profec-B after 20 psi. The Blitz unit goes in the car tonight, but that's with a completley new setup. The car right now is running 535s w/ head work, fresh block, stock ported exhaust manifolds (new inconel soon to be), etc.... check my profile for the details. Those are very good #s Chris. #192 of all U.S. TT Zs
Follow Ups	More info on my dyno when I had SP 500s - Seb 15:42:48 01/05/03 excuses excuses... - TARGETZ 15:49:41 01/05/03 Hey Seb, who does your internal work? - ZBlacktt 15:54:03 01/05/03 Re: Hey Seb, who does your internal work? - Seb 16:00:14 01/05/03 When will the inconel mans be available? - Marshall 16:21:35 01/05/03 Can't say yet on both - Seb 16:38:09 01/05/03 good enough for a mclaren...good enough for my z :) - Chris(NJ) 17:13:29 01/05/03 thanks seb....makes my #s even more believable (n/m) - Chris(NJ) 17:09:22 01/05/03
Post a Followup	You cannot reply to this message because you are not logged in.