Subject	cheaper solution>>>>
Posted by	Spectrum (WI) on January 01, 2003 at 12:40 AM
	This message has been viewed 59 times.
In Reply To	Custom "Z" battery tie down posted by 3335hs on December 31, 2002 at 03:16 PM
Message	Go to Ace Hardware or any good hardware store and buy some small steel and aluminum stock. -1/2" od square stock -aluminum "U" channel that is designed to fit snug over a 1/2" of square stock. The steel provides the strength and the aluminum provides the good looks. Just drill holes where you need them and use the stock rods for the tie downs. You can hand polish the aluminum pieces and put a good coat of clear to prevent oxidation. I will have pics of this setup with a custom cover that is painted to match the car later this spring. Total cost about 10 bucks.
Follow Ups	Custom "Z" battery tie down - 3335hs 15:16:36 12/31/02 I would buy, if it looked zweet. (n/m) - Milo (San Antonio, TX.) 15:19:16 12/31/02 me too, if it was a little cheaper. :-) (n/m) - Pure-Evil 15:19:59 12/31/02 Depending on Look and a little lower price, for sure. (n/m) - Generation 17:11:23 12/31/02 i have access to CNC (everything) - goixiz 16:16:29 12/31/02 I would probably be in (n/m) - Audicon 20:00:38 12/31/02 cheaper solution>>>> - Spectrum (WI) 00:40:48 01/01/03 I think the point is to have a Z logo on it though (n/m) - gschroeder 01:17:29 01/01/03 Interested, I'd like to see pics before committing though. (n/m) - RezidentEvil 11:55:37 01/01/03
Post a Followup	You cannot reply to this message because you are not logged in.