Subject	You just need to loop it around the runners and be sure not
Posted by	wcoffey on December 31, 2002 at 3:48 PM
	This message has been viewed 52 times.
In Reply To	My mechanic pulled it by the plenum. It's fine. (n/m) posted by Milo (San Antonio, TX.) on December 31, 2002 at 03:08 PM
Message	2 get any of the hoses/brackets in the straps. Anyway you should loop it lower than I did with the straps. I'm familiar with the clearance of the engine hooked up to the crane via straps, but if you're not, you could have problems getting it out of the engine bay.
Follow Ups	Another engine pull - wcoffey 13:50:39 12/31/02 LOL....I thought you had a cutting torch in your hand - JMT-Z(St. Louis) 14:08:24 12/31/02 Yea, I split the engine in half with my plasma cutter (n/m) - wcoffey 14:29:54 12/31/02 congrats! - niXit 14:09:11 12/31/02 Me too ;) (n/m) - wcoffey 14:29:08 12/31/02 who's Z is that? Sweet wheels. (n/m) - sbsTT(MD) 14:32:56 12/31/02 Chris's (n/m) - wcoffey 14:40:34 12/31/02 oh yeah, lol. (n/m) - sbsTT(MD) 14:58:01 12/31/02 Uh, what are you lifting it by? - 3 double-0 ZX(Va Bch) 14:35:16 12/31/02 Z Plenum (n/m) - wcoffey 14:40:24 12/31/02 My mechanic pulled it by the plenum. It's fine. (n/m) - Milo (San Antonio, TX.) 15:08:42 12/31/02 KaZ has done it that way a number of times but >>> - 3 double-0 ZX(Va Bch) 15:24:32 12/31/02 Very true! Strap it up. (n/m) - Milo (San Antonio, TX.) 15:29:39 12/31/02 You just need to loop it around the runners and be sure not - wcoffey 15:48:18 12/31/02 Isn't that a lot of weight to put on the aluminum intake? - MikeH(Twin GT35BB Incon Z) 15:55:52 12/31/02 Dang, didn't think a lil ol' CRV could tow the Z. (n/m) - socos 15:05:11 12/31/02 Duh, it's got VTEC (n/m) - SactoTodd 15:20:25 12/31/02 What ever happened to Honduhmann, scare him off??? (n/m) - wcoffey 15:44:09 12/31/02 DAMN, how big is your garage? 4-car? (n/m) - SactoTodd 15:22:27 12/31/02 That's a 2-car, in diagonally (n/m) - wcoffey 15:43:36 12/31/02 Nice job! :) - SpdDemon13 (Baltimore) 03:42:57 01/01/03 Blown Headgasket (n/m) - wcoffey 20:51:33 01/01/03
Post a Followup	You cannot reply to this message because you are not logged in.