Subject	Grinding motor mounts for bigger turbos, cutting pipes for
Posted by	boileralum00 on December 29, 2002 at 10:42 PM
	This message has been viewed 64 times.
In Reply To	Any use for a Dremel tool on my Z? posted by Zcrup92 on December 29, 2002 at 10:31 PM
Message	new turbos, fabbing wastegate actuator brackets for new turbos, trimming oil drain lines for new turbos, trimming hard pipes when they are slightly too long... I'm sure you can find many more as well. Rule #1 - There's always a bastard!
Follow Ups	Any use for a Dremel tool on my Z? - Zcrup92 22:31:06 12/29/02 polishing/cleaning aluminum pedals, etc - djhh212 22:33:25 12/29/02 Grinding motor mounts for bigger turbos, cutting pipes for - boileralum00 22:42:31 12/29/02 ive used it in plenty of installs.... - Chris(NJ) 22:48:28 12/29/02 Dremel method for fuel injector replacement (n/m) - sebring1970 22:49:18 12/29/02 6x9 speaker install.. rear strut bar.... (n/m) - Red ZX (SoCal) 23:05:14 12/29/02 dremel built the beer bong (n/m) - genic 23:07:37 12/29/02 diamond bits make the other bong (n/m) - NC-Z 23:10:06 12/29/02 Just polished my plenum w/ my Dremel. Looks brand new (n/m) - thirteenthkind 23:39:00 12/29/02 Care to share the procedure you used? - ChristopherTheOne 02:45:32 12/30/02 Must have took you a year! (n/m) - Milo (San Antonio, TX.) 09:19:03 12/30/02 Use it in your effort to get rid of Bose - yt nitram 23:46:02 12/29/02 Dremels are Nirvana when you need them. - ChazZ 02:36:46 12/30/02 LOL...passenger airbag 0wnz your glove box! (n/m) - ChristopherTheOne 02:44:09 12/30/02 Hehe, that's if you can get a pair of gloves in there:O (n/m) - ChazZ 05:37:39 12/30/02 just bought one for xmas. used it for the Z already! - Z U N L 03:36:03 12/30/02 install side markers (n/m) - Carlos-91NA-2+2-5sp. 08:20:54 12/30/02 You can clean up a lot with the dremel, please tell me it's - Milo (San Antonio, TX.) 09:14:49 12/30/02
Post a Followup	You cannot reply to this message because you are not logged in.