Subject	Looks like you ghetto rigged the tee why don't you
Posted by	MikeH(Twin GT35BB Incon Z) on December 26, 2002 at 11:19 PM
	This message has been viewed 102 times.
In Reply To	CRAP! Almost burnt down AGAIN! Need help with fuel system> posted by robbyg on December 26, 2002 at 11:03 PM
Message	get 1/8 pipe brass female tee and two 1/8 pipe by 5/16 hose barbs to screw into each side. That's what I used. It will be so tight you won't have to use hose clamps. But I put them on anyways. No brainer and available at your local hardware store. Not need for Summit.
Follow Ups	CRAP! Almost burnt down AGAIN! Need help with fuel system> - robbyg 23:03:31 12/26/02 Looks like you ghetto rigged the tee why don't you - MikeH(Twin GT35BB Incon Z) 23:19:20 12/26/02 It should look like this, - MikeH(Twin GT35BB Incon Z) 23:38:18 12/26/02 get the stainless steel and reg hose clamps..no problem here (n/m) - Slowninja(Delaware) 07:23:14 12/27/02 Where did you get yours from? (n/m) - MoneyPitZ 07:24:55 12/27/02 Now there's a good setup! I'm going to Home Depot today... - robbyg 09:30:44 12/27/02 I dunno man, mine doesn't quite sound like yours>>> - SeedyROM 02:46:54 12/27/02 Yeah that's the tee I have! >>> - robbyg 09:26:51 12/27/02 anybody have a part number for the tee and fuel lines? - Bernie 10:35:48 12/27/02 Well Greg installed mine...don't know what to say! - SeedyROM 10:49:01 12/27/02 And I mated 5/16th braided line with the 5/16th tee - SeedyROM 10:49:47 12/27/02 5/16th? i thought it was 3/8... do u mean u used 3/8 line - Bernie 11:54:33 12/27/02 Got my fuel leaks fixed! >>>> - robbyg 17:12:53 12/27/02 if you still come to the dyno day, hopefully i can show you - Chris(NJ) 09:08:28 12/27/02 Hmm, I might be able to make it on Saturday... - robbyg 09:27:52 12/27/02 either one, whichever you wanted to do. and you do - Chris(NJ) 09:43:53 12/27/02 Yeah, Sat the 4th. Gotcha ;-) I'll see what I can do. (n/m) - robbyg 17:08:16 12/27/02 This is why my Z began its 9 month sit - Chip(GinnMotorsports) 09:10:31 12/27/02
Post a Followup	You cannot reply to this message because you are not logged in.