Subject	Good EGR elimination solution????
Posted by	B-Ster on December 24, 2002 at 4:04 PM
	This message has been viewed 132 times.
Message	Would it be o.k. to block the two outlets on the back of the drivers side exhaust cam valve cover while plumbing the two feeds from the intake valve cover (both sides) to vacum? Thanks in advance for the feedback/suggestions. Bryan
Follow Ups	Good EGR elimination solution???? - B-Ster 16:04:48 12/24/02 Sorry, meant PCV (not EGR). (n/m) - B-Ster 16:07:26 12/24/02 What I did>> - Chip(GinnMotorsports) 16:19:47 12/24/02 Copy cat :) (n/m) - Woody75 (Denver) 16:27:59 12/24/02 Same thing I was going to do but not yet done :-) (n/m) - Carlos Ramirez 16:49:20 12/24/02 I copied Chad (NSANY). (n/m) - Chip(GinnMotorsports) 17:06:47 12/24/02 i like mine better. but that's why it's mine. (n/m) - Halo Z 17:14:45 12/24/02 What? weld in new ports ? (n/m) - Keith58 17:14:53 12/24/02 I plumb mine to oild catch can. (n/m) - MikeH(Twin GT35BB Incon Z) 18:52:08 12/24/02 Wild idea for ya.... - RSR 17:08:52 12/24/02 I thopught of this, but did not want to go through - Chip(GinnMotorsports) 18:54:57 12/24/02 How the heck would doing that increase power? - cheezoto(torque GOD!) 00:19:42 12/25/02 Sounds like you've already decided that it doesn't.... - RSR 07:51:14 12/25/02 pumping losses? Instead of compressing the air in the crank - Chip(GinnMotorsports) 09:05:26 12/25/02 May I ask what is the purpose? Thanx. (n/m) - sasha 17:55:09 12/24/02 BEEN there, done that just ask me haha (n/m) - Z-Roc@NewOrleans 18:38:00 12/24/02 BTW, I finished my fuel system with your recommendations, - Chip(GinnMotorsports) 18:55:47 12/24/02 I wondered about that! You're welcome. (n/m) - B-Ster 22:46:18 12/24/02 Thats what i did - cheezoto(torque GOD!) 00:27:42 12/25/02
Post a Followup	You cannot reply to this message because you are not logged in.