Subject	POS...
Posted by	CatDaddy(OKC) on December 16, 2002 at 7:54 PM
	This message has been viewed 100 times.
In Reply To	what's wronge with the pics posted by Halo Z on December 16, 2002 at 06:45 PM
Message	1. The bracket is bent bad. It will not mount to a stock Z without an adapter. This one will never mount. 2. The vacumn end is hosed. Turns and the seal is broken. This was only used 1 day cause they trashed it trying to mount it and broke it. Worth? $0... Can't belive their trying to sell a broke POS. Was a good $100+ NISMO FPR. Belongs in the trash now.
Follow Ups	what's wronge with the pics - Halo Z 18:45:04 12/16/02 inlet/outlet port thingy is on the different side? - genic 18:52:51 12/16/02 tink about it bud. - Halo Z 18:59:22 12/16/02 brings a new meaning to 'sit and rotate' - genic 19:04:15 12/16/02 keyword "adjustable" - s3trios 19:11:44 12/16/02 nut/bolt combo = adjustable. (n/m) - niXit 19:17:00 12/16/02 ohh,ohh, pick me, pick me,,,I know (n/m) - speedr300z (ATL) 19:35:59 12/16/02 that you broke it? (n/m) - Carlos Ramirez 19:44:14 12/16/02 I think you over cranked a bit to much :-) (n/m) - Carlos Ramirez 19:45:27 12/16/02 i didn't even get close to it. (n/m) - Halo Z 20:00:40 12/16/02 POS... - CatDaddy(OKC) 19:54:21 12/16/02 i tried to bend it so it would get one bolt down, - Halo Z 20:07:49 12/16/02 I'm sorry... - CatDaddy(OKC) 09:45:33 12/17/02 You shouldn't put them on the back of your SCC mag. :) - AshsZ (King of FAB) 10:07:34 12/17/02 wrong again buck-o - Halo Z 15:53:44 12/17/02
Post a Followup	You cannot reply to this message because you are not logged in.