TwinTurbo.NET: Nissan 300ZX forum - Re: Re: Re: Re: need a source for stainless steel or aluminum sheet metal
People Seeking Info
 
   


     
Subject Re: Re: Re: Re: need a source for stainless steel or aluminum sheet metal
     
Posted by Bernie on December 14, 2002 at 8:35 PM
  This message has been viewed 37 times.
     
In Reply To Re: Re: Re: need a source for stainless steel or aluminum sheet metal posted by DAYTONAZ on December 14, 2002 at 08:14 PM
     
Message I'm located in Miami. I'll take anything that you have available. The brackets I'll be making are going to be anywhere from 2"x2" to 6"x8", so a few pieces of roughly 12"x12" (or even just a bunch of smaller scraps) would be just fine because I'll just cut them up myself. Give me your address and I'll send you a check or if you have paypal, I can just send you money that way too. Thanks again! :)

RACELOGIC GROUP BUY GOING ON NOW! Click for details

Bernie

Authorized sales rep for...

Datalogs every run... launches with boost in your 5-speed...
keeps turbos spooled between shifts... enables controlled power slides...
valet mode prevents abuse of your Z... unlike most factory systems, maximizes acceleration!

For more information, pricing, or to purchase a system,
feel free to e-mail me: bhsiao@newssun.med.miami.edu
or visit the website

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.