Subject	When CarbonTT installed his FMIC here, he had to cut the
Posted by	YugoBernie (NoVA) on December 11, 2002 at 8:29 PM
	This message has been viewed 56 times.
In Reply To	HELP-FMIC guys-just noticed a somewhat big issue (chip)> posted by Wagz on December 11, 2002 at 04:47 PM
Message	back edge off of the facia that he had, seems to me like you're in the same boat. Bernie Bilski berniebilski@comcast.net 1995 NISSAN 300ZX TwinTurbo 5 Speed in Cobalt Green 1989 YUGO GVL 5 Speed in Arctic White ZCCNV #390 ~ ECZA #368 "Like most 11-year-olds, I identified with the life of the rapping pimp."
Follow Ups	HELP-FMIC guys-just noticed a somewhat big issue (chip)> - Wagz 16:47:44 12/11/02 duct tape (n/m) - genic 16:54:18 12/11/02 and a hack saw (n/m) - sbsTT(MD) 17:09:05 12/11/02 nail polish to cover up any residual scratches. (n/m) - chivas 21:15:40 12/11/02 Its all about the Dremel Tool.......... (n/m) - JMT-Z(St. Louis) 17:17:07 12/11/02 I have the Apexi and the Stillen Front facia here is what - MikeH(Twin GT35BB Incon Z) 17:22:54 12/11/02 thanks bro-do u happen to have any pics of any - Wagz 17:23:54 12/11/02 I will have to take some (n/m) - MikeH(Twin GT35BB Incon Z) 17:35:27 12/11/02 ok here is what I would do.. - Carlos Ramirez 17:24:39 12/11/02 would u happen to have a pic of this - Wagz 17:35:18 12/11/02 The HKS BOV are crap. I sold mine for the Apexi also - MikeH(Twin GT35BB Incon Z) 17:39:10 12/11/02 Re: The HKS BOV are crap. I sold mine for the Apexi also - Wagz 17:53:00 12/11/02 sorry but yours were bad.. the Apexi suck because they push - Carlos Ramirez 18:43:42 12/11/02 I am using the stock fascia - Chip(GinnMotorsports) 17:27:14 12/11/02 shoot Twinturbopete an email. Here is his setup--> - 2-turbos 18:28:28 12/11/02 thanks-will do (n/m) - Wagz 19:37:53 12/11/02 That will hinder flow to the FMIC and provide warm air - MikeH(Twin GT35BB Incon Z) 19:42:08 12/11/02 When CarbonTT installed his FMIC here, he had to cut the - YugoBernie (NoVA) 20:29:08 12/11/02 lol seems that way (n/m) - Wagz 20:39:25 12/11/02
Post a Followup	You cannot reply to this message because you are not logged in.